1200 series 1 saschnes ignition fitting

[feelerguage]

Hi, I'm  trying to fit volker sachse ignition to my bike, BTZ ignition. being honest I'm not good at wiring, on the loom there is along block connector for wiring if anyone has apicture of this all connected up to above system, or can email a diagram of it with relevant colours I would be eternally gratefull.did not have much hair before but damn all now, thank you

 

[drikko]

It's on their website:- http://www.elektronik-sachse.de/ZDG3/start/header.php?page=3&ver=3.2&typ=Laverda%201000/1200%20180deg-Series%20II&path=LAVERDA/1000_180_II/&lang=en

Pins 2 and 9 get grounded, although the diagram only shows 2, but I do both on these. I must remember to ask Volker if that's necessary.

 

[redax5]

wrong 180 engine Drikko, he is after the Series 1 layout and by his description, he is talking about the original connector slab on top of the rear frame rail

Feelergauge, have sent you a pm, will send you the mounting instruction document direct
all is explained in there but the basics are, after installation there are no wires going to that connector block at all

let me know if pm does not come through

HTH
Red

 

[Yogi]

How's that holiday coming along, Red?

You surely must be getting shed withdrawals by now...

Yogi

 

[redax5]

How's that holiday coming along, Red?

You surely must be getting shed withdrawals by now...

Yogi

you have that right, looking forward to getting home

 

[mauricejota7604]

Feelerguage if you are stuck email me and I can walk you through it mauriceturner@optusnet.com.au