Drive screw rivet

[Mactriple]

To replace the homologation plate to the frame I need 2 round head drive screw rivets. The hole size is 2mm so what diameter drive screw do I need to correctly secure the plate to the frame? Also, given the limited number required where can I get these?
Ian

 

[The Three Dellortos]

Hi I hope this helps.... When I re-sprayed my Monty years ago  I used the steel centre from pop rivets just can't remember the size . just know it wasn't the 1/8inch...

                Cheers

                        Tim O Thy

 

[AJ]

Bevel Heaven has them listed under homologation tag rivet in the fastener section. Any good fastener supplier should have them in stock. Hammer drive screw or rivet.

Toolfastdirect UK

 

[Mactriple]

AJ,
I got the ones for Ducati plates from Bevel Rubber and they were way too small. Bevel Heaven doesn't detail size so I guess they are the same as the ones I have from Damien Birch.
Tim,
I may look at that if all else fails.
Ian