Laverda 100 engine assembly

L

lavrestor

New member
Hello, any one have a copy of the shop manual for a 100?  Current issues today.... setting up crank and cam timing...  is sealant between cases recommended, appears none used.  Any help is appreciated.
I have located all bearings and seals if any one needs help with them.
Cheers,
Mike
 
Shop manual??  Never seen one. :D

Got the paper gasket between the case halves?  Gasket sets are readily available.  I use Loctite 510 or 518 as well, been oil-tight for a couple of years now.

Providing you haven't disturbed the cam drive gears on the crank, just line up the line/dots on the cams with the lines scribed on the inside of the cylinder throat of the cases (near the cam bearing bosses) with the crank at TDC.  Look closely, you'll find them eventually.  Took me a while...

piet
 
Thanks Piet, I see the marks on the cams and cases. I will position the crank to TDC. This motor did not have a gasket in between the cases.
Thanks again,
Mike
 
You must log in or register to reply here.
Back
Top