chrisk
Hero member
- Location
- Brisbane, Australia
Can anyone tell me the length of SF exhaust studs? Please. :-*
SF exhaust studs
- Thread starter chrisk
- Start date
breganzane
Hero member
- Location
- NSW Australia
132.7mm
They might be shorter, I was measuring on an angle.
You of all people do not trust measurements from this Forum do you?
They might be shorter, I was measuring on an angle.
You of all people do not trust measurements from this Forum do you?
G
Grant
Guest
Over 5 inches long?
Wow.
Wow.
motoddrob
Hero member
- Location
- S/W Australia
breganzane said:132.7mm
They might be shorter, I was measuring on an angle.
You of all people do not trust measurements from this Forum do you?
Mine measure 128.3mm but that's the SFC so could be different. Could also be shorter as it measured it from a distance!
chrisk
Hero member
- Location
- Brisbane, Australia
How's a bloke going to get straight answer? 132.7mm, >5", 128.3mm.
Doh, now if someone comes up with a real figure I won't believe them. (banghead)
Do you expect me to believe that Laverda would have used whatever they had laying around when building their bikes?
Doh, now if someone comes up with a real figure I won't believe them. (banghead)
Do you expect me to believe that Laverda would have used whatever they had laying around when building their bikes?
phil37
Hero member
- Location
- Lincolnshire
they are 40mm long - either 8mm or 7mm diameter according to which era. Laverda part No for the 8mm ones is 31 133 162 - Regards - phil
G
Grant
Guest
Sounds better.
breganzane
Hero member
- Location
- NSW Australia
Touch? Rob...
40mm? Maybe I was reading 140? Or maybe the angle was obtuse??
40mm? Maybe I was reading 140? Or maybe the angle was obtuse??
chrisk
Hero member
- Location
- Brisbane, Australia
breganzane said:Touch? Rob...
40mm? Maybe I was reading 140? Or maybe the angle was obtuse??
Thanks Phil ................... It wasn't the angle that was being obtuse
mauricejota7604
Hero member
- Location
- Victoria Australia
On the sauce were we Steve (cheers) (drink) (drink) (drink)
Simonr501
Hero member
- Location
- Lympne, Kent. UK
I dunno what the problem is.
Just cut them to 200mm and if they foul on the forks then lop a bit off!
Look on the bright side, the nuts will take ages to vibrate off the end.
Just cut them to 200mm and if they foul on the forks then lop a bit off!
Look on the bright side, the nuts will take ages to vibrate off the end.
Laverda SF
Hero member
Not if you use Brass Nuts.
