SF2 Handlebars

[zorba75482]

I know bars and comfort are subjective but I figure somebody must have addressed this issue before. I have the stock bars on my SF@ and find that it is a bit of a stretch too them causing wrist ache and numbness after about 30 minutes riding.

Would like to have them raised about an inch and back about 2". Have a Tomaselli clutch perch and Grimeca master cylinder so need about 8" of straight from the bar end before any bends

Like the idea of BMW R90S bars but would have to weld about an inch on to each end.

Anyone found anything that might fit the bill?

 

[IAG]

Have you considered Brevettatos or Tommaselli Condors?

 

[AndyW]

I know bars and comfort are subjective but I figure somebody must have addressed this issue before.

Anyone found anything that might fit the bill?

I had the same problem with my own SF2 and fitted 'bars from a Darmah: sorted 8)

 

[Vince]

There used to be a Renthal site that had sizes and bend specs

 

[zorba75482]

Thanks guys, I will go dig some up. Old age sucks!

Steve

 

[mcnicol]

You could also use the original bars and try some handlebar risers. Lots of sizes available.

 

[markQLD]

There used to be a Renthal site that had sizes and bend specs

& there still is Vince old matey.  there still is.
http://road.renthal.com/shop/road-products/road-handlebars/road-se-bars    & click-on the spec tab.

i like the 758-01 'ultra low'.  Clyde's got 'em & SeFFie soon will.
but, some would suggest that i have got farken long arms ay.    8)

mark

 

[Dellortoman]

but, some would suggest that i have got farken long arms ay.    8)

Do your knuckles drag on the ground?