Torque settings - RGS clutch

[MickeyMoto]

Hello,

Just rebuilding the primary drive side of the Argy and cannot find the torque settings anywhere for the clutch bearing carrier and the 8 bolts through the cush drive rubbers.

I have tightened thenm to 10 lb/ft at present, but might need a wee bit more.

Did the crankshaft nut up ft....

Thanks for the help.

Mick.

 

[Paul Marx]

I'd just do them up nice and tight. Put a touch of blue Locktite if you're worried.
Ciao
Paul

 

[MickeyMoto]

Thanks!

 

[Reggie3cl]

Somewhere in the factory manual (which is in my freezing shed, where I'm not going ) there are general torque settings for various size threads.

 

[redax5]

just be aware if you lay into these bolts too hard you will break the alloy post off the back plate
seen a number of broken ones over time

I use Loctite and nip them up firm

 

[MickeyMoto]

Thanks all,

I'll go out to my shed and dig out the book, I have seen the general tightness table, but thought these may have a different setting. 

Too cold to work on metal at the moment......

Mick.