Wheel spacers 3C

[Vince]

I would like to confirm the position and width of the rear wheel spacers washers and assorted bits on a spoke wheel.Don't need super accurate dimensions,by eye with a steel rule would be fine.Is it the same setup used for a SF with the twin leader rear brake?Piet listed this on another thread and mine seems to be different.

 

[Dellortoman]

Does that mean your 12 mm misalignment was incorrect spacers?

 

[Vince]

Elephant stamp for you,paying attention.I am reasonably sure its got the right spacers,its the same as Marty's.But after reading Piets listing for an SF,same wheel.It sounded a bit different.I don't want to waste the blokes and my time,and bloody money.Just want to be absolutely sure I cover all bases.

 

[tom3c75]

The two big washers are 5mm thick.
The spacer is about 46.5mm - bit difficult getting the vernier in there.

 

[Vince]

Thats close to what I have,all but the outer washer,thanks,how about the right side?

 

[sfcpiet]

Yep Vince,

Same for both twins and triples with rear drum.

RH side has a stepped spacer #34 510 014 (to avoid contact with outer race of the wheel bearing) inside of the chain adjuster, about 5mm thick, then the nut without washer.  Thick washer once again under the axle nut.

HTH,
piet

 

[Vince]

Thanks Piet,be great to get a pic of the right side as well.[/color]The bike is a couple of hundred ks away and that side hasnt be apart since the chain and sprokets were done ages ago.