Heel Toe gear shifter Alinment

Vince

Hero member
Is there a typical alignment for heel-toe gear levers? Do they align in a straight line front to back, level with the top of the footpeg, or is the heel pad slightly higher or lower? Are both the toe and heel bits the same length forward and aft to the centerline of the footpeg? Does the boot heel usualy 20mm thicker have any effect.
 
Last edited:
Totally custom arrangement on my bikes, posties are flat.
Is there a typical alignment for heel-toe gear levers? Do they align in a straight line front to back, level with the top of the footpeg, or is the heel pad slightly higher or lower? Are both the toe and heel bits the same length forward and aft to the centerline of the footpeg? Does the boot heel usualy 20mm thicker have any eff
 
I'd say make up some dummy samples in cardboard or similar, Vince - or get someone to help you, and measure the height diffs when you are on the bike.
 
Totally personal preference Vince if you have the opportunity to make it to suit yourself.

With a cunning design, you can end up with minimal movement of your foot while snicking up and down through the gears. I prefer a higher heel lever.

A couple examples for inspiration;

DSCN9496.JPGDSCN0227.JPG125trl.jpg125 Sport.jpgimage0-1.jpeg20210914_130559.jpg

piet
 
Thanks, Piet, good info. As Q said, it's not easy to measure how articulated your foot is, so why reinvent the wheel when you can see what smarter designers have done historically? I will probably end up chasing this till it works to suit me. BTW, I am using the rearsets I already have with the pivoting foot pegs plus the bits I bought on here. They might not need any welding if I can sandwich the discs and pin arrangement it pivots on into one unit. That pin arrangement also allows some adjustability as well, and maybe the whole thing will be reversible back to standard if I dont end up liking it. Be a good time to straighten my bent gear lever from a previous woopsy.
 
Back
Top