750SF Motor offset.

[chrisk]

A bit of progress on the offset motor so that I can fit the 180 rear wheel. Have setttled on a 20mm offset.

FFS, if I could drop in some more shots I would!

 

[Vince]

Now if you only had some wheels.

 

[chrisk]

Be down there myself on the week of the 19th, catch up with you then.

 

[Paddy]

Just out of interest how does that work out with the centre of balance on the lump ? Have you stuck the headers on and carbs etc just to check clearances ? or are you going to custom make the bits to suit .

 

[chrisk]

Just out of interest how does that work out with the centre of balance on the lump ? Have you stuck the headers on and carbs etc just to check clearances ? or are you going to custom make the bits to suit .

The lump is clutch side heavy anyhow.

FFS, go here Paddy.
http://s1291.photobucket.com/user/laverdaledgend/media/SFWeightbias_zpsd4be844e.jpg.html?sort=3&o=9#/user/laverdaledgend/media/SFWeightbias_zpsd4be844e.jpg.html?sort=3&o=9&_suid=141991786296805618296407479018

Headers no problems and carbs should be OK (I think)

 

[Paddy]

Bloody hell.........there is a danger you might end up improving this 

 

[Cosi]

Bloody hell.........there is a danger you might end up improving this 

Put your safety gear away Paddy, the only danger is him building something with handling of a vrod

 

[chrisk]

Put your safety gear away Paddy, the only danger is him building something with handling of a vrod

Building something with handling of a vrod on some serious Italian steriods. Lets see how it ends up.  :-*

 

[phil37]

Hi Chris - I presume your 180mm tyre will be on a 17" rim - with motor moved 20mm to the right - you may well have some ground clearance problems - the oil filled outer g/box cover will probably ground with some serious lean angles. - Regards - Phil

 

[motoddrob]

What happen to the spine frame?

 

[Tippie]

Is it an SF frame? I can't check now but I didn't think there was much space between chain and RH frame member from std.