Factory Tool Identification

[helicopterjim]

I bought some factory tools recently and I also have a few duplicates that I was had previously. I have identified some but not all. I was hoping that someone here could identify them. Also if anyone wants any of the duplicates I would be more than happy to pass them on!

 

[helicopterjim]

These are the duplicates that I have ....... anyone interested just send me a PM or email.

 

[Paul Marx]

750 tools

C spanner is for holding starter freewheel
Spanner with serated indents is primary holding tool
Puller is starter freewheel puller
Bearing puller type is for rocker spindles or auto advance.
Circle portion with locating tooth and indicator I presume goes on starter freewheel as timing indicator.

As for the others?

Paul

 

[phil37]

The "T" bar spanner is for adjusting the clutch cable nut at engine end - the spanner with 2 prongs is to lock the dynamo pulley -  Regards - Phil

 

[Dellortoman]

The circular ring thing is for a bull's nose.