Freshening up Anodized BIts

[Rockitdoc]

why don't you try it then on the rear brake master...? 

I meant rear brake master cylinder.  Don't know why I called this the clutch slave.  ???

 

[3C-Wayne]

http://www.focuser.com/anodize.html

http://www.focuser.com/anodize.html

These guys sell do it yourself anodizing kits... but he won't do your parts...

 

[Davo]

So do Caswells. But it isn't all that expensive to get it done professionally anyway.

http://www.caswellplating.com.au/anodizing.html

 

[Rockitdoc]

So do Caswells. But it isn't all that expensive to get it done professionally anyway.

http://www.caswellplating.com.au/anodizing.html

I don'tknow how many of you have tried plating parts yourselves, but it is involved,and basically a science project.  Doable, but marginal results and lots of trouble.  Just my $0.02.

 

[Davo]

Mate, I took all my grubby Brembo and Tomaselli aluminium bits to Aeroplate in Kewdale, WA. He chemically cleaned them and re-anodised them back to as new glory for a lot less than the cost (time and money) of a DIY kit.

 

[Rockitdoc]

Mate, I took all my grubby Brembo and Tomaselli aluminium bits to Aeroplate in Kewdale, WA. He chemically cleaned them and re-anodised them back to as new glory for a lot less than the cost (time and money) of a DIY kit.

I have a plater at an airport (Rocky Mtn) nearby that does good work, too.  Seems aircraft bits need cad-anodize-etc. plating to be airworthy.  Much cheaper, a lot less time consuming, higher quality, and no mess (for me).

 

[chrisk]

That kit on youtube is out for me .... it says to read the instructions carefully!

 

[Davo]

That kit on youtube is out for me .... it says to read the instructions carefully!

Obviously didn't read the small print either then :- *Contains no G-Strings