gearbox sprocket & transfers RGA Jota

M

merlin

Senior member
Location
gunnislake cornwall
my Gbox sprocket has a flat face on one side and is dished around the splines on the other side,when I took it off the dished side was facing out towards the locking washer which had been badly damaged by the sprocket .which way should it fit  its not mentioned in the manual as far as I can see .also when I fit the laverda badges to the bike do I need to laquer over them or are they OK without laquer
many thanks
dave
 
The sprocket taper should be fitted to the inside, ie, towards the gearbox bearing.  The shaft splines are sometimes not deep enough to accomodate a flat rear side, therefore the countersink/taper.  Hope that makes sense...

piet
 
If you have the correct RGA1000 side panel badges from Wagners lacquer over them .For the tank, the replica stick on badges from Wolfgang look much better than transfers IMHO,and don"t forget the small Laverda badge on the tailpiece,also from Wolfgang.

Shaun
 
Be careful what you spray the badges with. If they are painted with an enamel, lacquer will crinkle the paint.
Dennis
 
Hello Dave,

there is a company here in Sydney in AUS who should have the complete set of graphics for a Sprint JOTA.  MOTO Graphics are their name in Lidcombe.
Around 5-6 years ago I gave them a set and they replicated them for me, including the metalised graphics that sit in the recess on the side covers.  They also did the 3Cross 3 legged cross motif that our JOTA came with when we purchased it new back in 1984.  I can't believe they would not have the artwork/dielines.
Given the strong AUS $ it may be cheaper to buy from within Europe if you are in Europe. 

 
You must log in or register to reply here.
Back
Top