HansGerch Full member Jan 12, 2012 #1 Hi there, although i have been looking several times on the 1000 head, i finally noticed: what to do with this head? give it a try, or trash it, or what? Regards, Roland edit: picture of involved shim added: very creative, it measured 3.15mm... Attachments rk.jpg 95.8 KB · Views: 122 rgk.jpg 92.9 KB · Views: 74 shim.jpg 24.5 KB · Views: 8
Hi there, although i have been looking several times on the 1000 head, i finally noticed: what to do with this head? give it a try, or trash it, or what? Regards, Roland edit: picture of involved shim added: very creative, it measured 3.15mm...
sfcpiet Administrator Staff member Location Germany Jan 12, 2012 #2 No Problems, Roland. I have a welder that can repair that without damaging the alloy around it. Can get it back to good as new. PN me if interested! piet
No Problems, Roland. I have a welder that can repair that without damaging the alloy around it. Can get it back to good as new. PN me if interested! piet
CLEMTOG Hero member Jan 15, 2012 #3 carefull Piet, there are lots of us who have heads like that on our "just in case" shelf, you could get busy! CLEM
carefull Piet, there are lots of us who have heads like that on our "just in case" shelf, you could get busy! CLEM
sfcpiet Administrator Staff member Location Germany Jan 15, 2012 #4 No sweat, Clem. Reclaimed several, works a treat! I'd be glad to have a little something to do to pass the time... piet
No sweat, Clem. Reclaimed several, works a treat! I'd be glad to have a little something to do to pass the time... piet
