Lawton Bushman sidestand braket

Yeah, think I took the main stand off too, the conversion works so well I never missed it.  Bloody wish I'd had that conversion when I first had the bike and my leg was still is a bad way after stacking my Z650, had several ooh shit moments tring to get on the thing in the early days...
 
I suppose we are all different.

I use the centre stand most of the time. Although being a short arse I flip the side stand down first before using the centre stand when getting on/off the bike so I can get on/off easier.

I don't know how long Italian persons legs are, but they must be longer than mine! All my bloody trousers are ragged at the bottom as well. I will have to hang like a fruit bat to stretch the legs I think.
 
My Italian neighbour is a shorty..He'd have to use a ladder to climb on the Jota  :LOL:

The MV Agusta F4 is very tall too...I'm going to lower it in the close season I think... Can be a bit of a challenge on some car parks...They're not all flat ...

joe
 
Thank you..

If anybody would like to place an intent to order..pls drop me a pm or an email so that I contact you back when they have been produced.

cheers,

joe
 
If people commit and pay using paypal, they don't get charged until you send them out.  Don't get stuck with unsold stock.
 
How spooky - idley searching "centrestand" as a search word to try and find the length of the springs for my SFC1000 stand and I discover this thread from, er, today, with much needed info!

I have a bushman kit on my ceriani forked 1200 and it works a treat, except I definitely had to chop the end of the centrestand foot extension, which makes it even more difficult to heave up on the rare occasions I need to/can be arsed, which isn't often, admittedly.

Anyway, was going to order similar for my 3cl endurance rep and hadn't realised Jim doesn't do them anymore - so will happily have one off you Joe when ready, and intend to remove the centrestand off the rep, I mean, it's soo un-Bol D'Or...(and weighs 5 lb if the SFC one is anything to go by).

Thanks Joe and well done!

Dave
 
If you make a cutout for the gearshift boss.  See the working drawing via the thread link above.
 
Why not make the 3D model available for everybody?

bracket.jpg


Download eDrawings executable: www.laverdafinland.org/cape/kuvat/bracket.zip
 
I didn't do the 3D model, I just had a mate tidy up the working drawing I drew by hand from the original one that Rob supplied.  I guess his progam (Solidworks?) just did the 3D automatically.   My mate did my first machined one- the first I made to fit my LHS change bike from my own drawings was by hand out of 10mm alloy.
 
veravista said:
What, like this?
Click to expand...

No, that is only a jpg-image.

Maybe I wasn?t clear enough. Download the bracket.zip from link I provided above. Unzip the file and run bracket.exe. It will open a program as shown below. It is a Solidworks 3D model viewer ?eDrawings?. You?ll be able to rotate the model, measure it, get mass properties?

bracketexe.jpg

 
You must log in or register to reply here.
Back
Top