Oil cooler to crankcase

swesty

swesty

Junior member
Thread specifications needed please, approx 12mm and 16mm both by 1.5mm pitch, is this correct?
 
It's for a '79 1200T, I bought a new one but it's too big so is being returned.  I've since turned up a couple of blanks so just need to put threads on them
 
The oil cooler adaptor between hose and cases is different depending on if you have an early (3C type) oil cooler or a later one.
RGS type may need a different one again, from memory.
 
Are they all metric, someone did suggest they might be mixed u.n.f one end metric the other.  Can't put my hand on a thread gauge at the moment but does M16x1.5 and M12x1.5 sound right?
 
You must log in or register to reply here.
Back
Top