Re sizing rear mc

P

paulincayman

Hero member
Location
Cayman Islands
Does anyone have info or a source for resizing a stock 3cl rear mc for use with a brembo p32 caliper..From 16mm down to 12mm..
I had read about it  ages ago being done on a front  mc on a BMW R80ST  owners forum ..but I can find that now...
I want to use my stock rear mc set up with a new p32 caliper as part of the gsxr wheels conversion. I have the caliper purchased along with the mount from Red so kind of committed at this point.
Cheers
Paul
 
I used the original M/C when I up graded to Gixxer rims and Brembo caliper. Sort of works ok or about the same as the original set up. Would like to up grade to the appropriate M/C but that would involve too much fucking around with bracketry to fit one and I don't have the enthusiasm to deal with it atm. Motodd frame.
 
Hi guys, I?ve done the big wheel conversion on my jota and I use a alpine master cylinder on a p32 rear caliper and works great. Prior to the wheel conversion I was using the alpine master cylinder on the Jota with the standard rear caliper and it worked great😀👍
Tom
 
ozijotati said:
Hi guys, I?ve done the big wheel conversion on my jota and I use a alpine master cylinder on a p32 rear caliper and works great. Prior to the wheel conversion I was using the alpine master cylinder on the Jota with the standard rear caliper and it worked great😀👍
Tom
Click to expand...


Did the Alpino mc bolt right up to the stock mounts? Although that particular mc is probably as rare as rocking horse s**t these days. 
I see Laverda  Paradies has the correct item but it is hugely expensive and an exchange deal to boot.
 
Yes, bolted right on and look?s the same as the original only slightly longer in the outlet neck. You can search for Ducati Pantah one?s as I think the?re the same, maybe find a cheaper one. Probably a lot more Pantah?s built than Alpino?s.
Tom
 
You must log in or register to reply here.
Back
Top