Redax Sachs ..Joes wiring diagram

[jotajoe]

I have just completed the installation of the Redax Sachs Generator and Ignition upgrade to my 180 series 1 jota which was previously BTZ.

I made a simple diagram of the wiring required as it related to the harness and drew it up on my board before going anywhere near the bike. This helped alot as I went through the removal of the old system and the installation of the new kit.

Anyway, it works good.

Joe

 

[IAG]

How does it run and did you check voltage at the battery? I think it's a great system and also cleans up the wiring a bit. Job well done!

 

[jotajoe]

How does it run and did you check voltage at the battery? I think it's a great system and also cleans up the wiring a bit. Job well done!

Hi and thank you.... I didn't help myself by having a 6 month break in the job. Doing the diagram before I left the country back in December , as "caveman" as it is was key to doing it with a little aplomb 

She is running perfectly ...I didn't need to remove the starter to thread the wires through from the alternator housing, didn't even tape them up..went through real easy.

I did put a video up of the start up in what did you do to your Laverda section

https://www.facebook.com/photo.php?v=10152388602857594&set=vb.577232593&type=2&theater

and yes in the excitement I haven't checked the alternator output but I do know she is charging.It started raining a few moments after i started her...I'll do that this morning....The side panels are on now and I am as happy as a "pig in muck"...

Cheers

joe

ps I'll draw a clearer and neater diagram and post it up for those that may find it useful.