RGS Selector Drum

K

kainsworth

Junior member
Hi, how does the RGS selector drum come out? Do I have to split the bearing and curly bit from the main drum? Thanks for any tips Kevin
 
Hi that was a photo of the internet, it raining hard here and I did not want to get wet! My cases are filthy and I want them vapour blasted clean, the rest of the moving bits (crank, pistons, head etc) are away being sorted. The hole in my crankcase where the shaft passes through the ball bearing is of a smaller diameter than the shaft selector drum hence it can't pass through the hole even if the ball bearing was removed?
 
Thanks all it's now out, what the manual didn't make clear was that the bearing and curvy bit have to be removed off the shaft to get the selector drum out, not via the bearing hole but by twisting and lifting up where the gear shaft would have been
 
You must log in or register to reply here.
Back
Top