Standard wiring harness block connectors

N

Nick

Full member
Hi,

I'm going to install an aftermarket speedo onto the Atlas. I prefer to keep the standard block connector in case I want to retro fit. Ideally I'd like to put the digital output wires into a block that I can just plug into the standard Atlas connector (probably the same as with the Laverda triples).

Is it possible to buy these blocks and if so where? If not has anyone else come up with an alternative solution that saves the original block on the main loom?

Thanks

Nick :-)
 
Not sure about the Atlas, but do you have the blocks with the round, bullet-type connectors?  Which size do you require?

piet
 
Not familiar with the specific items, but I think this is the type of connector usually used by Suzuki etc, and shared with the later ND stuff;
http://www.easternbeaver.com/Main/Elec__Products/Connectors/110_Connectors/110_connectors.html

Cheers
SteveB
 
breganzane said:
Not familiar with the specific items, but I think this is the type of connector usually used by Suzuki etc, and shared with the later ND stuff;
http://www.easternbeaver.com/Main/Elec__Products/Connectors/110_Connectors/110_connectors.html

Cheers
SteveB
Click to expand...

Excellent site, Steve. 

Those connectors were used towards the end of production, late 3CL and RGS models.  Pity they don't list the early types that Laverda used, imediately after the seperate spade connectors as in the 750/3C.

'90s Harleys have very similar connectors to these earlier Laverdas, available in more sizes as well.

I have a small stock of the early connectors, hence my questions.

piet
 
You must log in or register to reply here.
Back
Top