Tank Liners POR (PPC) vs KBS

G

ghwallice

Hero member
Location
Ipswich
Has anyone had experience with these kits? Is one better than the other, or is there a better kit?

I took a "long term laid up" steel tank Ducati for a run yesterday and ended up hitchhiking. The cause was an incredible amount of rust inside the tank that had clogged the internal filter and caused the old hose to blow off the efi pump.

It was a great day though! The conversation with the absolutely gorgeous 22 yo blonde that stopped to pick me up was worth breaking down for.....

Regards, Greg
 
Ive used Caswell's. easy to use and no problems so far.
Helps to have a long handled small brush on hand to get to places it dosnt flow to, like the top of the frame tunnel.
 
Have just done a tank with the MCS sealer kit (I think it is just a rebranded KBS kit)
While I can't say if it is any good I used it because a local bloke here recommended it and stated he has done plenty of tanks and never had a problem using the stuff.
(I didn't actually want to do anything as thought I had cleaned tank well enough but then found a pin hole and obviously very thin around bottom seam so bit the bullet. Hopefully prepped it well enough!)
 
OK. I'll give the Caswells a go. I see there is a Caswell's importer(?) in Melbourne.

Paul? is there a supplier in Brisbane?

Regards, Greg

(PS the gorgeous blonde, Amelia (aka Meelsie) was my apprentice when she was 17/18. She moved on about 3 years ago and I haven't seen her until she picked me up the other day. It was just a coincidence. She used to have modelling agencies chasing her then...a very unique girl then, a very unique young woman now)
 
there's a mob called A1 Motorcycles in Nerang that do the whole job for you, and properly.. reasonable pricing and good people to deal with.
Saves 'amateur' issues in application I reckon..
Just dropped a tank last week, and pick up is this Friday..

8)
 
You must log in or register to reply here.
Back
Top