3C - Crankcase oil line fitting thread size = M12 x 1.5mm?

N

NJS

New member
Location
UK
Hi,
For a Triple - 3C- I did a search and I think that the crankcase threads for the oil lines are M12 x 1.5mm? Correct??
I have fittings - AN6 adaptor to M12 x 1.5mm.
(I then plan to use 3/8" or 9.5mm oil line using AN fittings to the cooler I have)

I just wanted to double check engine / block thread size is correct?. (Laverda Paradies - I see says M12 - but not pitch)


Thanks!



 
Rusty Spokes said:
NJS. no one has jumped in to reply..so if needed I will remove and measure my 3c oil line fittings..Piet or others surly know off the top of their heads?
Click to expand...

Dunno what thread you will find, but I've come across 3 different ones, apparently all factory standard... even including one imperial size!  ::)

M12x1.5 is one of them. 

Good luck.

piet
 
Hi,

Many thanks for replies, and this was to give me confidence I'm on the right lines (literally) before I insert adaptor. I did just check and received today some M12 x 1.5mm nuts - which screwed onto the original adaptors removed - which threaded down okay- so it matches without a cross thread worry into crankcase.

The adaptors I obtained were as per link below for info and seem fine.

Thanks again Gents for your help...

https://www.ebay.co.uk/itm/AN-6-AN6-JIC-Flare-to-M12x1-5-METRIC-STAINLESS-STEEL-STRAIGHT-MALE-Adapter-/302467661059

 
Brett said:
If its metric and 12mm then will be 1.5 as going into alloy
Click to expand...

Dunno how reliable that rule is Brett. I was fiddling about with my Mitsubishi the other day and discovered a plumbing fitting (coolant pipe) that was M12 x 1.25.

Anyway, seems the OP is sorted, so all is good.
 
You must log in or register to reply here.
Back
Top