3cl crankshaft sprocket nut tension?

[ghwallice]

Crankshaft sprocket nut tension.  Have done clutch and primary chain. I thought I had seen it somewhere, even thought I had a list of tension settings for the Breganzes, but can't find them. Thanks, Greg

 

[2622]

Here ya go remember to clean and degrease the thread before using some loctite... ideally you should also a new tab washer.


http://www.laverdaforum.com/forum/index.php?topic=84506.0

 

[mcnicol]

And if you use a new tab washer, be VERY careful to support the end of the crank when you bend the tab over. Very easy to knock the end of the crank a little bit out of alignment and end up with the outer bearing spinning a hole through the outer case. Fixable if it happens but it's a crankshaft out job (= $$$$  :)

Ken

 

[Grant]

What, do you bash it with a hammer????

 

[ghwallice]

Thanks for the info. Appreciated, regards, Greg.

 

[chrisk]

What, do you bash it with a hammer????

(dunno) Just a thor hammer.

 

[Paul Marx]

10kg, if not acquainted with metric: bloody tight.
Paul

 

[CLEMTOG]

or for the anglophiles
FT

CLEM

 

[Paul Marx]

or for the anglophiles
FT

CLEM

Anglophones Clem, you don't have to like them.

Paul