Neutral Light

tribonnie

tribonnie

Full member
Location
uk
77 Jota, took off my wiring loom and after labelling and photographing everything all ok except neutral light permanently on. I have Rupes diagram and the Tim Parker book but they show some differences. I have a switched 12 volts through the bulb down to switch. Is this correct, does the switch only close for neutral, connecting to earth. Thanks Richard
 
Paul Marx said:
Presuming you haven't taken the switch out in which case shimming is likely awry, you have an earth problem.

Paul
Click to expand...
Paul, don’t think I have an earth problem, bike is running which I think indicates crankcases are earthed. Wil try to test switch without taking it out. I have not taken the switch out so I guess shimming ok.
Thanks Richard
 
At risk of stating the obvious, what happens when you remove the faston connector to the crank case switch? Usual to insulate that faston connector ie should it touch the crankcase or deformed profile. HTH j
 
You must log in or register to reply here.
Back
Top