Dellortoman
Hero member
- Location
- Tasmania, Australia
You can drill out a broken bleed nipple if you're careful. I've only done it once but it worked OK.
Jo said:The remains of the bleeding nipple stick deep down in the hole. Only way to get those out would be EDM. I did not realize this in
my 1st attempt as the DPO placed a setscrew above to (successfully) seal the entire thing.
EDM, probably welding and time-serting is altogether doable ? but certainly would involve some cost and time.
Searching for a good used one is the 1st route to follow imho.
Cheers
Jo
Piranha Brother 2 said:Calipers without threads can't be converted for use in Laverda style Ceris - the part where the holes are is outboard, same place the holes in the forks are.
2018-04-03 12.35.29 by Grant Duguid, on Flickr
P4051840 by Grant Duguid, on FlickrIf at all it looks a tad too green-ish for me as far as I can tell from the pictures .Grant said:Depending on quality and angle of light it looked blue-ish, green-ish or even just silver.
Grant said:This is the closest I can show to compare POP's shade with another painted in a BMW colour (I recall), likely Arctic Blue.
Maybe Stefan can jump in to correct me if wrong, as it's his bike (on right).
P4051840 by Grant Duguid, on Flickr
LJ said:Solid pastel blue, original, I know of two bikes with it, no idea of code but maybe get a match with my sprayer, owner uses same one as me.
Gravelroad said:Fond memories, Grant. Quite close with your guess, but no cigar. It is called Glacier Green, BMW code 334. Name is a bit misleading, in reality it looks in most lighting
conditions blue. Only at dim lights a slight greenish faint will show up. It was a near perfect match to a bit of original paint left at the rear of the side covers.